Free Shipping*
Lower 48. Orders over $100.
2 Year Warranty
On all our radios.
5-Star Rating!
$499.99
JL Audio XDM200/2 200 Watt 2 Channel Amplifier
Item #: XDM200-2
$499.99
Out of Stock
Free Shipping
Description
Best JL Audio 2 Channel Amp
The JL Audio XDM200/2 is a 200 watt, 2 channel amplifier that uses class D circuitry and the "go-to" among JL Audio professionals that are looking for the best Class D amp that JL offers.
75W x 2 @ 4 Ohms
The XDM200/2 puts out 75 watts per channel at 4 ohms, 100 watts per channel at 2 ohms, and 200 watts at 4 ohms when bridged.
This Amp Will Never Overheat and Shut Off
The thing that makes the XDM200/2 amplifier better is JL's Advanced Rollback Protection. Simply stated, this amplifier will never overheat. Here's what happens. When the XDM600/6 starts getting warm, the amplifier will limit the peak output slightly without changing the gain. So, the amplifier "protects" itself without shutting off and without you noticing. Because it is only rolling back the peak output, as the listener, you don't know that the amp has gone into "protect" mode becuase it continues to play and it is only affecting peak output levels. So, you can play your music as loud as you want, for as long as you want, and you don't need to worry about the amplifier overheating. The amp gets warm, the amplifier will limit the voltage to cool itself off, then when it gets back to "normal" operating conditions, it goes back to full-power mode.
Works for Both Cars and Boats
The JL Audio XDM amplifier line replaces both the XD and the M series amplifiers from JL. Before, there were two separately amplifier lines that were essentially the same, but one was built to withstand the marine environment. JL decided to make it simpler and merged them to create the XDM series. These amps have a "Car/Boat" switch that allows you to select he environment. In "Boat" mode, JL has set a low-pass filter at very high frequencies to eliminate the noise that comes from some of the electro-mechanical devices that are used on boats. If you are installing the amplifier in a car, set it to "Car" mode. If you are installing the amplifier on a boat, we recommend setting it to "Boat" mode to ensure that the auto-stabilizers and other devices on your boat don't generate noise through your stereo system.
Product Specs
Circuitry
Class D
Output @ 4 Ohms
75W x 2 RMS
Output @ 2 Ohms
100W x 2 RMS
4 Ohm Bridged Output
200W x 1 RMS
Frequency Response
12 Hz - 22 kHz
S/N Ratio Referred to 1 W
>84 dB (A-weighted, 20hz - 20kHz Noise Bandwidth)
THD+N @ Rated Power
<1% @ 2 Ohm Per Channel
Input Range
200mV - 4V (Low Level Only)
Minimum Power Wire Gauge
8 AWG
Fuse Rating
20 A (AFS,AGU or MaxiFuse)
Filters
Hi/Lo/All Pass Filters
Crossover Slope
12 dB/octave
Filter Frequency Range
50 Hz - 500 Hz
Infrasonic Filter
No
Remote Level Control
Optional HD-RLC (Sold Separately)
Channel Input Switch
N/A
Pass Through Output
Yes
Source Channel Selection for Pre-Outs
N/A
Dimensions
6.85"(W) x 7.09" (D) x 2.05" (H)
Warning: Cancer and Reproductive Harm - Q&A
Q&A
{{ totalQuestions }}{{ (totalQuestions === 1) ? ' Question' : ' Questions' }} with {{ totalAnswers }}{{ (totalAnswers === 1) ? ' Answer' : ' Answers' }}
Ask a Question
Question
Name
Email
Submit Question
A confirmation email will be sent to your email address before your question can be posted.
Success!
Uh Oh
Page {{ currentPage }} out of {{ totalPages }}
{{ question.asker.display_name }}
QUESTION{{ textDecode(question.content) }}
{{ answer.answerer.display_name }}
Store Owner
COMMUNITY ANSWER
{{ textDecode(answer.content) }}
Page {{ currentPage }} out of {{ totalPages }}
Reviews
Reviews
{{ reviewCount }} Customer {{ (reviewCount === 1) ? 'Review' : 'Reviews' }}, {{ reviewAverage }} Average Score
Page {{ currentPage }} out of {{ totalPages }}
{{ review.user.display_name }}
Verified Purchase
{{ formatDate(review.created_at) }}
{{ textDecode(review.content) }}
Page {{ currentPage }} out of {{ totalPages }}
You might be interested in the following:
Recently Viewed Items:
