Our 1970-1981 Camaro Kenwood dual dash mount speaker consists of two, Kenwood 3.5" speakers that are mounted on a board with a bracket to give you stereo sound from the original, mono location. This Kenwood 1970-1981 Camaro dual dash mount speaker is designed to act like your original 4x10 speaker, but provide better sound. The 1970-1981 Camaro Kenwood dual dash mount speaker has two, 4 ohm speakers and is designed to work with our modern, replacement radios. If you have an original 8 or 10 ohm radio, you may still use this speaker, but you will have to wire it in series and may or may not have to add an inline resistor. Please be careful when using with an original mono radio as improper wiring may fry your original, 8 or 10 ohm radio.
Standard vs. Kenwood Excelon Speakers
We recommend upgrading to the Kenwood Excelon speakers. The standard Kenwood speakers that are used in this speaker will work, but there is nothing speical about them. However, for a litlte bit extra, the Excelon speakers just sound better. The Excelon line is Kenwood's top-of-the-line offering and these speakers
will work directly off of the radio and will sound even better if you add an amplifier.
Speakers
Standard Kenwood
Tweeter Material
Dual Cone
Surround
Foam
RMS Power Handling (Per Speaker)
10 Watts
Sensitivity
89dB @ 1 W/1m
Features
⬤
Low Cost, Replacement Speaker
⬤
Very Low Power Handling
⬤
Water Resistant Cone
Kenwood Excelon
Tweeter Material
Silk Dome (Soft Dome)
Surround
Rubber
RMS Power Handling (Per Speaker)
50 Watts
Sensitivity
83dB @ 1 W/1m
Features
⬤
Silk dome tweeter for warm, rich, balanced sound
⬤
Kenwood's Top of the Line 3.5" Speakers
⬤
Polypropylene Cone with Withstand UV and Moisture Better than the Standard Paper Cone
⬤
You can't go wrong with Kenwood Excelon!
The Excelon Speakers are worth the Upgrade Cost.
- 1970-1981 Chevrolet Camaro